IMPORTANT INFORMATION REGARDING CORONAVIRUS (COVID-19) Read More
Category: Accessible Table

DIY Lap Desk Stabilizing Pad

AbleData does not produce, distribute or sell any of the products listed on this website, but we provide you with information on how to contact manufacturers or distributors of these products. If you are interested in purchasing a product, you can find companies who sell it below.

Lap Desk Stabilizing Pad is a stabilizing component that has been added to a commercially available lap tray to provide a stable work surface and encourage upright posture. For individuals with limited posture, motor control as a result of a neurological incident.   It can be difficult for individuals to sit on a couch or in a recliner and read a book or magazine or write. With the lap desk stabilizing pad, the user sits on a piece of material with 4 buckles attached. The lap desk is buckled to the material to prevent the tray from tipping.

Advantages:

Portable

Stable - does not tip over

Improved upright positioning

Technical Specifications: 

Step 1:  Materials

1 Lap Tray (sample styles shown)

1 Bottom Piece: 24 inches x 12 inches rugged material (denim or upholstery)

4 - ¾ inches fastex buckles

8 pieces of ¾  inches trap material cut to 7 inches lengths

4 - # 1/4-20 x 1 inches machine screws with lock nuts (length may change based on the lap tray purchased)

8 washers

4 - #10 lock nuts

NOTE: This was fabricated for an average adult. Size of the bottom piece may need to be modified to accommodate smaller or larger individuals.

Step 2: Sew a hem around the bottom piece

Sew a hem around the bottom piece to keep it from fraying. Iron on tape could also be used as a substitute

Step 3: Prepare strap material

Melt the edges of the strap material with a heat source (heat gun preferred) to prevent fraying. Take 4 of the pieces, fold them in half, and thread through one side of the fastex buckle (doesn't matter which side as long as they are all the same)

Step 4: Sew the straps to the material

Sew the 4 pieces from step 4 to the material.

Step 5: Preparing remaining straps

Take the remaining 4 straps, fold in half, and thread through the other half of the fastex buckle . Make a hole in the strap material for the bolt to go through.

Step 6: Attach straps to lap table

Drill a hole in each corner of the lap tray where you would like to attach the straps. Location should coincide with the location of the matching side of the buckle on the bottom piece. Attach the straps from to the tray using the ¼ inches machine screws, washers, and nuts.

Step 7:  Instructions for use

1. Set the bottom piece on the seat surface of the recliner, couch, or chair.

2. Have the user sit on the material. Be sure the material is not bunched or they are not seated on a buckle.

3. Place the tray over the user’s lap

4. Snap the buckles together to hold the tray in place

Author:  TCFDATDept

Available

Price Check
Price: 
0.00
as of: 
05/11/2015
Additional Pricing Notes: 
Cost of supplies and materials to complete project.
Seller(s): 
DIY Lap Desk Stabilizing Pad